Thanks again for all the advice
My biggest problem with my 60csx was difficulty reading maps on gpsfiledepot. Now I loved the maps, especially when up close. The problem was when I zoomed out a little and wanted to see major points of interest like intersections in the trail and mountain peaks. I couldn't find anything more than a few hundred feet out when zoomed out because there were so many topo lines on the map. I wound up using a friends maps on his cell phone, which were more basic but were easier to locate POI further away then a few hundred yards.
I don't think shaded relief is necessary to fix this, but I'm definitely not the expert on maps. I was hoping I could load multiple maps, allowing me to use a less cluttered map when zoomed out and the higher detailed maps here on gps filedepot when zoomed in. That's why I was looking at higher end units that could display multiple maps, not multiple maps overlaid on one another, but separate maps that I could easily switch back and forth without waiting several minutes to load a new sd card. Is there a way to do this?
My biggest problem with my 60csx was difficulty reading maps on gpsfiledepot. Now I loved the maps, especially when up close. The problem was when I zoomed out a little and wanted to see major points of interest like intersections in the trail and mountain peaks. I couldn't find anything more than a few hundred feet out when zoomed out because there were so many topo lines on the map. I wound up using a friends maps on his cell phone, which were more basic but were easier to locate POI further away then a few hundred yards.
I don't think shaded relief is necessary to fix this, but I'm definitely not the expert on maps. I was hoping I could load multiple maps, allowing me to use a less cluttered map when zoomed out and the higher detailed maps here on gps filedepot when zoomed in. That's why I was looking at higher end units that could display multiple maps, not multiple maps overlaid on one another, but separate maps that I could easily switch back and forth without waiting several minutes to load a new sd card. Is there a way to do this?