GPSFileDepot.com
 

News:

Welcome to GPSFileDepot!

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - unklbuck

#1
Thanks again for the info
after the master reboot, update of the software and using map installer, all seems ok

Shout out to the pa topo guy...nice job on that
#2
Boyd
did a master reboot
and
all the items you mentioned
got the topo 2008 and now trying the patopo
great help.........thank you

JOhn
#3
1.  rec active
2. topo enabled, marine disabled
3. how do i set the detail to max?
4. i loaded the 16 maps from patopo11.  when i go to map enabled, all I see are 3 maps from  patopo and these were in the middle of the state.  Maybe i should try and just load my quadrant in Butler PA and see what that gives me?

--if you load let's say 10 quadrants, should you see all 10 in the enabled block?

#4
No help
Saw the profile, was on marine, changed to recreational but still same map info, streams and RR

thanks very much for the reply
#5
Updated the Oregon 400c, got Garmin base camp and mapsource updated and talking to the garmin and then downloaded the patopo11, NE USA Part 3 and I have the topo US 2008

All show up in BAse Camp and Mapsource

When i pick the maps to load --success.  However, when i go to map display in the Oregon, I do not see any topo detail.  IN the PAtopo11, i see train tracks and water, that's it.  NO roads, contours, detail at all.

There doesn't seem much to do in the setup for the garmin and I enabled the topo. 

Probably missing something easy.... but need help

going to give this a go in Western PA using paddleboards going down the creeks.  Got a few ULIs, but think i am also going to try this Badfish SUP.

Thanks for any help....John