Messages

Thanks for Replies Guys,

Update:

1. Confirming: all maps loaded from mapsource onto SD card
2. Confirming : No maps in any files on garmin unit internal memory
3. I tried this: removed all maps from SD card except Garmin NA 2011. Confirmed by looking in map set-up in unit. Then I sent a variety of CA TOPO 11 tiles to card. Zooming in, maps not observed, no change from before. Map shows as CA Topo 11 in Setup as enabled. Renaming on SD card has no effect.
4. CA Topo 11: Monterey (wn) San Jose (ws)"  are typical map/tile names that show up in MapSource and on SD card and in Garmin map set-up. There are never any 8 digit numbers associated with any CA Topo 11 tiles. I have selected them all to double check. In contrast, Old CA Topo shows the 8 digit numbers for the tiles in all circumstances, and I can always see those maps..... hmmmmm. could this be the problem? Not sure



unclejosh

Guys,

Thanks for the replies

This is what I did in response to your replies:

1. Selected 2 tiles only from CA Topo 2011 - 2 areas where I reside and hike.
2. Sent the two tiles to SD card. Renamed file montsj.img on SD card
3. Disabled Old CA Topo on Garmin
4. Confirmed two new CA tiles/maps were enabled on Garmin
5. The name of the two tiles on the Oregon are "Monterey (wn) San Jose (ws)" These are the autonames given by Map Source. Unlike old Ca Topo, there are no numbers assigned to the tiles. I do not know if this matters, that is the format of the tile name.
6. Went outside, locked, and still no topo maps with high magnification

I tried the above multiple times to no avail.

Other notes:
All my maps reside on the SD card.
There are two instances of the old CA Topo with identical tile numbers that show on the Garmin. However, there is only one .img file on the Garmin that represents the mapset. Not sure how to cure this either.

Thanks in advance for any ideas or insights.......

Josh

Guys,

Would appreciate any help here:

I can load selective map quadrants and observe them on my Garmin Oregon 450 if I use the older version of CA Topo.

When I send CA Topo 2011 in its entirety or even just one quad, the map does not show on the unit, but it does show in the system file as a map that I can enable or disable.

I have had a similar issue with TX Topo.

I can send to either unit or SD card and I still cannot see.

Whatever name I give it does not make a difference either....

Any help appreciated.....

Josh