Messages

Thanks again Boyd.  I got the maps downloaded and loaded on my new Garmin 64.  Unfortunately I can't figure out how to display the one I want.  My Gps screen will only show my pre-installed worldwide base map.  I followed the instructions entitled "How to change which map is displayed on a Garmin GPS".  The 64 was identical to the first set on instructions on the tutorial.  However, when I enabled my desired map & disabled my pre-installed map, no map was displayed on the GPS screen.  How do I get my new Trail map to display?

If I'm supposed to first install maps using MapManager, then how it that done?  When I turn it on  it only says "No compatible maps were detected"

Thanks Boyd for clearing up a few items.  I have no maps on my new 64 except the included worldwide base map.  I would like to download trail maps for NM.  I redownloaded the base camp software.  Following the tutorial, "How To Load Maps On My Garmin GPS Unit", step 4, I right-click on my device name.  There are 9 choices, but there is no choice labeled, "Install maps".  I am unable to go any further.   

I am unable to install the Garmin MapInstall software to obtain your maps.  I have a Mac computer and a Garmin GPSMap 64 GPS.  The Mapinstall software displays the message, "No unlocked maps were found for this device" and the continue button is unlit and I am unable to move from that display page whenever I turn on the software.  I am also unable to uninstall the software as it will not drop into the trash bin.  Strangely a wide green upward-pointing arrow is displayed above the software icon.  I don't know what more to do.