Messages

I had the exact problem with Paiute map for Utah.  I followed the directions here...loaded My Trails...but still could NOT see the Paiute map!  I then did what else was suggested...UNinstalled the Paiute map.  Re-installed the map but CHANGED the directory to the Garmin directory, which is where the My Trails automatically downloaded.  YAY...now both the My Trails and Paiute maps appear in BaseCamp!!!

THANK YOU for the help and the great ATV map.  Your additional information is VERY helpful to this "newbie"!
    I did try to cut and paste the map legend and then print it...but I couldn't get a good copy.  Your response here will make that much easier for me to do...so again, THANK YOU.

    Thank you for replying.  I am in Wisconsin and trying to learn all of this.  I read in one of the Q&A that you need to zoom below 8 mi.  I panned to Roanoke, WV and zoomed in.  I NOW see the map I downloaded )
    I'm assuming the maps I download from this site are all "overlays" onto the default maps on my GPS system...is that correct?
    Do you know what maps I need to keep "enabled"...Worldwide DEM Basemap, NR...TOPO U.S. 100K?  If I want to run trails in northern Wisconsin and then take a trip to West Virginia...do I have to disable one downloaded trail map before going to the other? 
    Is there someplace to read and learn the colors, symbols, etc. used in these downloaded trail maps?
    If you are an ATV enthusiast, are there map suggestions you could provide?  I AM trying to learn and appreciate any help you can provide.

I need help with a Garmin Montana 650t...for the first map I want on this GPS...I downloaded West Virginia ATV map.  It comes up on my BaseCamp account and the ATV trails look great.  Problem, I can see that I've installed it to my GPS - but no matter what I enable or disable in the Map Selection, it does NOT produce that map on the screen.  Does anyone know what I must have set incorrectly?