Messages

seldom,

thanks for the reply...Before I left SC I put all the maps and info on a laptop in case, as it happened, there was a screw up that wouldnt show up until we got to moab...

the key was that map button on the MApsourse toolbar to hilite the sections to transfer.  all is good now...thanks for your help and TG for the internets!

david

i DLd the Utah topo maps to my PC and Mapsource.  I was able to transfer my waypoints into my Etrex Legend hcx, but the maps themselves didnt transfer...when i click MAPS on the left panel it shows 0 mb...

i did all this in So Carolina before i went to Moab.  Now that I am in Moab I can see that the topo maps are not installed onthe GPS...

I can see the waypoints, but they are like on a blank page...

thanks for any advice...

david

Hi,

Raw newbie here, so I apologize if this has been answered a million times; I tried to find an answer before posting...

just got the Legend HCx, downloaded the South East US maps at  http://www.gpsfiledepot.com/maps/state/sc, put it in MapSource, then into the GPS unit, all OK so far

Then I added the Utah map the same way, and I could see it on the GPS, but the SE map had disappeared.  I used the Setup/Map/info....the Utah maps are there, but not the SE maps anymore.  Is this normal?  I have a 4gb card in the unit.

thanks for any advice...

david