Messages

Thanx everyone,

It finally works.
I used an other cardreader.
Now when I put the Card into my Dakota 20,
there is only the BaseMap and not the maps MapInstall put on the card.
And yes I do know how the turn maps on and off on the Dakota.
   
Name :    MICRO SD CA
   Type :    Partition

   Disk Identifier :    disk1s2
   Mount Point :    /Volumes/MICRO SD CA
   File System :    MS-DOS (FAT32)
   Connection Bus :    USB
   Device Tree :    IODeviceTree:/PCI0/EHC1@1D,7
   Writable :    Yes
   Capacity :    3,62 GB (3.621.216.256 Bytes)
   Free Space :    563 MB (562.978.816 Bytes)
   Used :    3,05 GB (3.051.159.552 Bytes)
   Number of Files :    0
   Number of Folders :    0
   Owners Enabled :    No
   Can Turn Owners Off :    No
   Can Be Formatted :    Yes
   Bootable :    No
   Supports Journaling :    No
   Journaled :    No
   Disk Number :    1
   Partition Number :    2

The card info, copied from Disk Utility Info.
The Number of Folders isn't right and the Number of Files isn't right.
There is a Garmin folder on the card with a gmapsupp.img 3,05 GB file.
The Used Bytes are right.
What is or went wrong?
Is it a MapInstall problem, a Dakota problem or a user problem?

No, an empty one

Thank U

[The disk was not ejected properly. If possible, always eject a disk before unplugging it or turning it off.]

I everybody,

I'm trying to put some maps on a from Garmin bought Micro SD Card, using Garmin MapInstall.
I follow every step from the 'How to....., by Dan Blomberg... When MapInstall gets to the point were it is transferring the mapsets onto the MSD Card, it is stalling and the time remaining runs up to over 4 to 5 hours.
Eventually it says that:The disk was not ejected properly. If possible, always eject a disk before unplugging it or turning it off. , which is not the case. It is still there.
This happens with what ever map/ parts of maps I want to put on the MSD Card. When I open the card I see a Garmin folder in there, sometimes with a gmapsupp.img file. There is nothing there, no maps, when I put it into my Dakota 20! 
I have Garmin MapInstall 4.0.0 software  and Mac OS X 10.7.3 software.

The question is what do I do, or what goes wrong and how can I fix it?