Messages

thank you sir. 

I understand how I would create multiples, but how would I name them on the card? I thought it only accepted one file name. And then, do I simply enable/disable them via the map menu if I want them available for loading?

I am attempting to load ~4000 US TOPO 2008 segments onto my Oregon 300 using an 8GB microSD chip. I have used Mapsource v6.15.6 to select the desired segments (about 2/3 of the US which represents the max I have read can be sent to the unit due to # of segment limitations) and told it to send to the chip. It started running last night and 12 hours later is only ~70% done.

The PC is fairly modern with 1 GB of RAM. I don't think it is a PC deficiency. To confirm I also replicated the process this morning on my work PC (shhhhhhh...lol) which is brand new with tons of cpu and RAM and it is still running slow. I am using a standard 8 GB USB drive at work instead of my microSD chip inside the unit (cuz it is still at home running...).

I realize the Build Map Set process is PC dependent, the transfer to the unit/USB device occurs after the map set is built. So right now I'm lookign for any guidance to speed up the PC process othe than selecting fewer maps. I want one map since I have the space to store it, don't want to have to switch between maps. What is the dang deal with this thing running so slow?

I'm also curious where this file is being built on my PC. I wanted to check to confirm it was actually being built! I see no large file being produced anywhere related to this process, I searched the whole drive. Maybe it is being done all in memory? That could explain my growing process memory footprint and swap file space.

I have this eTrex Venture HC. I can only get about 25% of my state (Virginia) map into it because it has a small amount of internal memory. This is OK if you only hike in a portion of the state, or if you want to keep loading in different areas (which oveweites the over areas). I find it a pain in the butt. The unit does not accept any kind of expansion memory so I am stuck with this. I actually roam all over the state with my outdoor activities so am frequently swapping different maps into it.

Still, it is a cheap unit and this may be all you need. The free topo maps are pretty good.

Thanks. That's exciting.

I'd like to view the My Trails map within Mapsource but have it overlay the NE USA Topo map so I can see roads and such. Can I make it do this?

My gal is an archeologist and will be traveling extensively throughout the island. Are there any maps I can download into mapsource and transfer to our Garmin eTrex Venture?

Thanks!

<edit>

Duh, I figured it out!