I'm new at this and unfortunately have botched something as I try to come up to speed.
I'm running XP SP3. I installed the latest Mapsource and it seems to run.
I downloaded the NE USA Topo Part 1 and ran its installer. I had the installer use a folder on D: rather than the default since C: doesn't have much room. The installer completed normally. But Mapsource doesn't show a map in the left pane. So I tried to use MapSetToolkit to install the map but after filling out the form its Install said: "Family ID exist".
I didn't install cgpsmapper because it isn't needed when using a map from GPSFileDepot. Or at least it isn't used explicitly. The tutorial says to load both MapsetToolkit and cgpsmapper before the flow splits and the path I took didn't need cgpsmapper. But MapSetToolkit mentions cgpsmapper so now I'm not sure. I prefer to install as few programs as possible but maybe I went too far here?
I expected the installer to make NE Topo show in Mapsource and wonder if this didn't happen because I installed in a non-standard place?
EDIT: View/Switch to Product showed NE Topo and selecting it made the map visible.
View/Map Detail/Highest shows a nice Topo map
EDIT2: Some areas of the map don't show roads. The area around Lyndonville, VT has no roads, at 2mi scale there is a gray line around the area and roads end at that line -- Rt 91 is missing a section there. Similarly for the area east of Lake Champlain & south of Rt 89. Not sure if it was an install problem or the map is missing these details.
But Mapsource's left pane doesn't show it and it says 0 maps
How do I get Mapsource to recognize this map?
Thanks, John
I'm running XP SP3. I installed the latest Mapsource and it seems to run.
I downloaded the NE USA Topo Part 1 and ran its installer. I had the installer use a folder on D: rather than the default since C: doesn't have much room. The installer completed normally. But Mapsource doesn't show a map in the left pane. So I tried to use MapSetToolkit to install the map but after filling out the form its Install said: "Family ID exist".
I didn't install cgpsmapper because it isn't needed when using a map from GPSFileDepot. Or at least it isn't used explicitly. The tutorial says to load both MapsetToolkit and cgpsmapper before the flow splits and the path I took didn't need cgpsmapper. But MapSetToolkit mentions cgpsmapper so now I'm not sure. I prefer to install as few programs as possible but maybe I went too far here?
I expected the installer to make NE Topo show in Mapsource and wonder if this didn't happen because I installed in a non-standard place?
EDIT: View/Switch to Product showed NE Topo and selecting it made the map visible.
View/Map Detail/Highest shows a nice Topo map
EDIT2: Some areas of the map don't show roads. The area around Lyndonville, VT has no roads, at 2mi scale there is a gray line around the area and roads end at that line -- Rt 91 is missing a section there. Similarly for the area east of Lake Champlain & south of Rt 89. Not sure if it was an install problem or the map is missing these details.
But Mapsource's left pane doesn't show it and it says 0 maps
How do I get Mapsource to recognize this map?
Thanks, John