Topics

I have an Oregon 400t with software version 3.20. It came with the U.S. 100k topo set preloaded.

I put in a 4GB microSD and downloaded all the Colorado 24k topos which were named Colorado Topo Maps. I used your cotopo_install.exe by selecting the whole state which turned pink as stated in the tutorial.

I put them on my GPS in two ways:

1) Load onto microSD from laptop then put chip into GPS
2) Load into GPS while microSD is in the GPS.

Then I go: setup -> map -> map information select map -> disable topo u.s. 100k, enable Colorado Topo Maps, disable West DEM Basemap Topo U.S. 100k (what's this?)

But always only the 100k U.S. topo appears.

Can anyone tell me what I'm doing wrong? Thank you!