Messages

Oh I wish I knew !! The pre loaded US map displays even thou there's no check mark in the "map info" for it to load. I can zoom in and locate the Everglades area but I can't tell if it's from the US map or the Florida map that I loaded. Do I have to zoom into the US map to get to the loaded Florida map ? I had expected the Florida topo to display as a separate map. Can the Florida map be layered under the US map ? If this is the case is there any way to get just the Florida map to display by itself ? I sure appreciate your help.

When the Florida topo map would transfer to the Garmin but not display I thought the internal memory might be full so I bought a SD card for it. Have a successful MapSource transfer to the card
and it shows when connected to the computer but it still will not display. The US map is the only one that displays and it doesn't have the check mark by it in the map information, the Florida topo is checked. I'd greatly appreciate any help in getting the Florida map to display.

It was all in MapSource just as it should be. It finished and said the transfer was complete.

I loaded the whole state and a separate download of the Southern part wanting to get as much detail of Everglades National Park as possible. When it wouldn't display I deleted it all and started over just loading the southern part but that didn't help.

What I'm looking at is the US map which is all that displays. I've enlarged it all the way and minimized it all the way but still it's just the US map.

I loaded the Florida topo in my Garmin nuvi 205W but it will not display, only the US map that is pre-loaded will display. The Florida topo is listed in "Map Info" with a check in the box beside it, no check in the US map box. Any help will be appreciated I'm out of things to try !!