I am extremely new to Garmin Etrex 20X and possibly overlooking something simply.
I downloaded three maps from GPSFileDepot (DesertSouthwest, My Trails, NCTOPO11) to Basecamp and can see them and use them totally as expected within the PC format.
I placed a new, 64Gb, PNY, microSD, formatted in ExFat in the GPS unit and did a standard install according to GPSFileDepot directions. Everything worked exactly as expected.
I can see the files on the SD card (in Mass Data mode) under removeabledisc/Garmin/ . . . and they are saved as Disc Image Files.
When I go to the unit and look to "enable" the maps, however, they do not show up on the list (only the maps on the internal drive show up).
Earlier, I put those same maps on the internal drive (prior to buying an SDmicro) and they worked without any problem on the unit (from the internal drive).
I switched the micro SD card to a purchased Garmin map system, and the map on that Garmin system shows up on the map list, can be enabled, can be used on the unit.
What am I doing wrong? Is it possible that the formatting (ExFAT vs. FAT32) or size of the SD card is too large?
Any assistance would be appreciated.
I downloaded three maps from GPSFileDepot (DesertSouthwest, My Trails, NCTOPO11) to Basecamp and can see them and use them totally as expected within the PC format.
I placed a new, 64Gb, PNY, microSD, formatted in ExFat in the GPS unit and did a standard install according to GPSFileDepot directions. Everything worked exactly as expected.
I can see the files on the SD card (in Mass Data mode) under removeabledisc/Garmin/ . . . and they are saved as Disc Image Files.
When I go to the unit and look to "enable" the maps, however, they do not show up on the list (only the maps on the internal drive show up).
Earlier, I put those same maps on the internal drive (prior to buying an SDmicro) and they worked without any problem on the unit (from the internal drive).
I switched the micro SD card to a purchased Garmin map system, and the map on that Garmin system shows up on the map list, can be enabled, can be used on the unit.
What am I doing wrong? Is it possible that the formatting (ExFAT vs. FAT32) or size of the SD card is too large?
Any assistance would be appreciated.