Text only | Text with Images

GPSFileDepot Forums

General Category => General Discussion => Topic started by: tdi2000 on May 11, 2015, 12:54:05 PM

Title: How to send maps from two different mapsets to GPSmap 60CSx
Post by: tdi2000 on May 11, 2015, 12:54:05 PM
I will be visiting North Carolina and Virginia in the near future. I successfully downloaded vatopo11 and nctopo11 and installed both on my PC. If I open MapSource I can see both sets of maps and can select either one and view it on the PC. I can also send one of the mapsets to my GPSmap 60CSx and view it there. The sending process overwrites whatever mapset is already on the GPS.

I want both NC and VA to be on the GPS at the same time (I believe I have sufficient memory). How do I get both mapsets onto the GPS simultaneously?

Any help/suggestions would be appreciated.

Thanks.
Title: Re: How to send maps from two different mapsets to GPSmap 60CSx
Post by: popej on May 11, 2015, 04:09:32 PM
Select tiles form a map, switch to second map, again select tiles and in the end send them all to GPS.
Title: Re: How to send maps from two different mapsets to GPSmap 60CSx
Post by: tdi2000 on May 11, 2015, 07:25:18 PM
Thank you popej. That was way too simple for me to think of it myself.

I thought if I switched to another mapset the selections would be lost. Not so.

Thanks again for a prompt and very useful reply.
Title: Hello
Post by: Inosesosis on October 09, 2019, 03:42:45 PM
Hello everyone on the forum :)
Text only | Text with Images