I've been able to load both the NC topo map and My Trails from this site onto my eTrex20. I downloaded and installed BaseCamp and Mapsource. When I enable the maps and disable the other maps that came on the unit I'm still just seeing the white (transparent) screen with the marker.
I had BaseCamp and Mapsource off during the installation. The maps show in Basecamp. On the transparent screen the scale is about 500 feet for a half an inch or so. Should both of these maps be enlarged in Basecamp before loading them onto the unit? If so how do I do this in Basecamp? The topo map was loaded first and then My Trails.
I've read 8 pages of this forum and cannot find what I'm doing wrong.
Thanks for what I've learned and what I've yet to learn.
Jim
I had BaseCamp and Mapsource off during the installation. The maps show in Basecamp. On the transparent screen the scale is about 500 feet for a half an inch or so. Should both of these maps be enlarged in Basecamp before loading them onto the unit? If so how do I do this in Basecamp? The topo map was loaded first and then My Trails.
I've read 8 pages of this forum and cannot find what I'm doing wrong.
Thanks for what I've learned and what I've yet to learn.
Jim